The B60 series Jocelyn Steel Crossarm are used either for crossarm construction or sidearm construction for single phase to three-phase circuit application (13.8 kV to 69 kV), mounting holes are pre-drilled in accordance with the power utility crossarm-drilling guide.
Vertical SideArm Brace Hot dip Galvanized
These Jocelyn braces are used for side arm construction and double primary support either for 13.2 kV to 69 kV circuit application.
Alley Arm Brace Hot dip Galvanized
Alley Arms, crossarm mounted to one side of the pole, mount at a 45-degree angle and come complete with solidly riveted lineman step.
These braces are mounted to the side of the arm by a machine bolt and attached to the pole with two
1/2-inch machine bolt or lag screw.
Flat CrossArm Brace Hot dip Galvanized
Flat Crossarm Braces, used in pairs, are an inexpensive means of aligning and supporting crossarms.
Mounting hole diameters are 7/16-inch for 3/8-inch crossarm mounting bolts and 9/16-inch for pole mounting with a 1/2-inch lag screw or machine bolt. Hole centers are 1-inch from the brace ends.
Angle Brace Hot dip Galvanized
The Jocelyn two - piece and one piece double span angle brace are used to support heavy crossarm construction. Braces are attached to the underside of the crossarm with 1/2 - inch bolts or lag screws and fastened to the pole with a 5/8 - inch bolt.
Angle Brace Double Span Hot dip Galvanized The Jocelyn one piece double span brace are used to support heavy crossarm construction. Braces are attached to the underside of the crossarm with 1/2-inch machine bolts or lag screws and fastened to the pole with a 5/8-inch machine bolt.
Diagonal Brace Hot dip Galvanized The JFI Diagonal Drace are extension fixtures used as tension member of alley arms to compensate for unbalanced load.
Back Brace Hot dip Galvanized
The JFI Back Brace are extension fixtures used as tension member of alley arms to compensate for
Product Quick Finder
Select Product Category then select Product on the drop down